New belt attached by admin | May 4, 2013 | My Journey, Uncategorized | 4 commentsJust finished off mounting the new belt/cog. Pictures and test drive to come. 4 Comments Filipe on May 5, 2013 at 1:59 am Looking good ! can’t wait to see the running test. Rigo on May 10, 2013 at 4:49 am Nice to know you are up and running again. I am about to buy the cogs and belts. Could you send the link for them? Maybe names and descriptions? Thank you for the posts! over and out on May 10, 2013 at 6:09 am Check out the comments in this post for details of what I order and some recommendations. http://howtomakeanelectricskateboard.wordpress.com/2013/04/21/re-working-begins/I would recommend the I purchase the HTD belts but the GT2 is probably more appropriate for the needs. Gates is the company that make these see their product description for more details: http://www.gates.com/brochure.cfm?brochure=7911&location_id=11536Also I would recommend something a little wider just for the extra grip if possible. Mine was 9mm, maybe a 12mm would be good.Also note: My back wheel is 70mm. The large cog I purchased is too large for the wheel. I should have got something with more clearance.http://www.sdp-si.com/ is the company I purchased theme from. They have a good website. sean on August 12, 2014 at 11:39 pm where did you get the cogs?